page contents

Replacing Starters

Replacing Starters

“Do I need to replace the Sunbed Starter as well?” 

Honestly, it's up to you! The job of the Sunbed Starter is to offer fast and safe ignition to power up the sunbed tube, once the tube is alight it offers no further help. So if the old sunbed tube starters are powering up the old tubes they will probably continue to do so on the new set. However, old starters do cause sunbed tubes (new and old) to turn black at each end, this will not impact the tanning output as very little UV is produced near the lamp ends, but it might look unsightly. Sunbed Tube Starters are relatively cheap so it's just as well to install new when re-tubing.

There are no products listed under this category.